Cable Fault Finding With The A-Frame; Cd Signal Method - Radiodetection RD400PDL-2 User Manual

RD400PDL-2/PXL-2 User Guide
mA
FF Normal
Lf FF Boost
8k Multi
33k
65k Connect 24V
User Hz Connect 50V
Radiodetection
Radiodetection Ltd. Radiodetection Corp.
Western Drive PO Box 623
Bristol BS14 0AZ, UK Ridgewood, NJ07451, USA
On/Off
A-V-O Mode Up
Line Select Down
01/MH1054L1ENG/3
Serial No.
12V
Adaptor Connect
mA
FF Normal
Lf FF Boost
8k Multi
33k
65k Connect 24V
User Hz Connect 50V
Radiodetection
Radiodetection Ltd. Radiodetection Corp.
Western Drive PO Box 623
Bristol BS14 0AZ, UK Ridgewood, NJ07451, USA
On/Off
A-V-O Mode Up
Line Select Down
01/MH1054L1ENG/3
Serial No.
12V
Adaptor Connect
Lf 8 33 65
a
b
Fuse
Fuse
Press the A-V-O key to display current (mA).
Press the Up or Down keys to set the required
output current level (typically 20 mA). In situations
where there is a high degree of interference
selecting a higher current may be desirable.
If it is not possible to obtain sufficient current,
check connections to cable/sheath and Ground
Stake. If necessary change position of the ground
stake or pour water around the stake in dry or
sandy conditions.

Cable Fault Finding with the A-Frame

CD Signal Method

Carry out the procedure in the 'Transmitter Setup'
section.
Using the Transmitter Mode key, move the pointer
so it points to the CD icon, the pointer will flash.
Press the Select key to set the Transmitter to the
CD mode, the pointer will stop flashing.
Note: Lf will also be selected as the CD signal
utilizes this frequency.
Connect the A-Frame to the Accessory Socket of
Receiver.
Switch the Receiver On and select CD using the 'f'
key.
FaultFinding