Depth; Current; Accessory Socket; Error Codes - Radiodetection RD400PDL-2 User Manual

Precision Locators
8 33 65
Lf
12
Lf 8 33 65
8 33 65
Lf
14
Lf 8 33 65
RD400PDL-2/PXL-2 User Guide
a
m
b
a
mA
b
13
a
b
a
b

Depth (12)

Press to display depth from Receiver to target
line/sonde when directly over line/sonde.
Depth measurement may not be available in all
modes on some PXL-2 models.

Current (13)

Press once to obtain current value (mA) of active
target line signal when directly over line, except in
Power or Radio modes.
CD - Read (PDL-2 only)
Press the Current key twice to select Current
Direction indication when in CD mode. Current
Direction will be indicated by the forward/backward
arrows on the LCD.
CD - Reset (PDL-2 only)
Hold down Shift key and press Current Key, LCD
will display 'rSt'.

Accessory Socket (14)

Pointer indicates when Accessory Socket has been
selected. On some Receiver variants selection is
automatic when accessory is connected and on
others selection must be made by pressing
Peak/Null key.

Error Codes

Error Codes are displayed where gain dB level
normally appears accompanied by an 'Err' message.
Operational Errors
Error #9 - Indicates that signal is too small or too
large to measure Depth/Current. Check Transmitter
settings.
Error #11 - Indicates a strong overhead signal.
Error #21 - Indicates that depth to target
line/Sonde is beyond Depth measurement range.
Error #22 - Indicates CD signal missing in CD
mode.
Error #44 - Indicates Lf signal missing in CD
mode.
Equipment Errors
When Error Codes #15, #16, #17, #18, #19, #23
and #24 are displayed you must consult your
Dealer/Supplier.