77: [Adjust Fusing Temprtr to Transfer Paper]
Adjust the fusing temperature at which to allow paper feeding after warming up.
Paper feeding starts when the fusing unit reaches the temperature defined by the selected mode. Select
one of the following modes:
1. This is the normal printing mode.
2. This mode reduces excessive luster or hot offset when printing on thin paper just after printing on
thick paper.
3. This mode reduces fusing errors by increasing the fusing temperature at which paper feeding is
allowed.
4. This mode reduces paper jams in the fusing pressure roller by decreasing the temperature of the
fusing pressure roller at which paper feeding is allowed.
5. This mode cannot be used on this machine.
6. This mode cannot be used on this machine.
Setting Items
[Adjust Fusing Temperature to Transfer
Paper]
78: [Adjust Adding Fusing Temperature 1]
Adjust the fusing unit's accumulated temperature for a specific time after a job starts.
Depending on the operating environment, the fusing temperature may drop before paper is transferred
to the fusing unit. Use this function to prevent the fusing temperature dropping.
Fusing temperature must be adjusted if a fusing error or abnormal luster occurs after three to ten pages
of a multi-page job are printed.
Press [+] to increase the temperature and [−] to reduce it.
Setting Items
[Adjust Adding Fusing Temperature 1]
79: [Adjust Adding Fusing Temperature 2]
Adjust the fusing unit's accumulated temperature for a specific time after writing starts.
Depending on the operating environment, the fusing temperature may drop before paper is transferred
to the fusing unit. Use this function to prevent the fusing temperature dropping.
Max. Value
Min. Value
6
1
Max. Value
Min. Value
30
0
Setting Values
Step
Unit
1
None
Step
Unit
1
degree(s)
107