Automation Modes - Solid State Logic Duality SE Operator's Manual

A A u u t t o o m m a a t t i i o o n n
A A u u t t o o m m a a t t i i o o n n S S e e t t u u p p O O p p t t i i o o n n s s
The following entries in the SSL / Misc / Setup menu are used to configure automation operations:
Glide frames:
Rollback threshold frames:
In Mix show:
Mix Update Mode:
Automated switches turn off on: Select whether the off function of automatable switches is sent on
5 5 - - 2 2 2 2
Sets the ramp time in frames for the automation SNAP mode. (range
0 - 255)
Sets the number of consecutive, decrementing frames that the system
needs to see to determine if a Rollback has taken place. The range is
2 - 10; the default is 2 frames. Increase as required if a Rollback occurs
when you stop the timecode master.
When using the automation, you have a choice of what is displayed on
the consoles channel scribble strips (and below the Group and
Master fader levels in the Centre Section TFT screen). The choices
are:
Automation Mode: displays the status of the faders – Auto, Safe or
Manual;
Channel names in Mix running: displays the channel names once
Execute is pressed in automation,
Channel names: displays the channels names regardless.
Sets the default automation mode at the start of an update Mix
(Replay / Absolute / Trim).
the down-press or release of the button (Press / Release).
D D u u a a l l i i t t y y S S E E O O p p e e r r a a t t o o r r ' ' s s M M a a n n u u a a l l