Solid State Logic Duality SE Operator's Manual page 144

T T o o t t a a l l R R e e c c a a l l l l
R R e e s s e e t t t t i i n n g g C C o o n n t t r r o o l l s s
A A u u t t o o m m a a t t i i c c a a l l l l y y R R e e s s e e t t C C o o n n t t r r o o l l s s
A double press on a fader status button, or on Set Sel or Set All, will reset all the non-latching functions on
that channel strip, channel strips selected on the central routing panel, or all channel strips respectively. The non-
latching functions are:
• Input section buttons
• Dynamics assignment and routing buttons
• EQ and Insert buttons
• Aux on/off and EFX reassign buttons
• Main and Track bus routing
• The Solo Isolate function (indicated by the ISO display beneath the TR display's SOLO button)
• Fader position (indicated by a yellow arrow-head).
• Offline trim position.
M M a a n n u u a a l l l l y y R R e e s s e e t t C C o o n n t t r r o o l l s s a a n n d d A A u u t t o o - - S S c c a a n n
All latching switches and rotary pots must be reset manually. The AScan (auto-scan) softkey can be used to highlight
where manual resets are required – when pressed, the console scans all the channels, starting from Channel 1, until
it finds a discrepancy. Correctly reset channels are indicated by their green fader status LED being lit; the first
channel with any discrepancies is indicated in the centre section TFT screen, as well as by its green fader status LED
flashing and its TR display appearing in its bay's TFT screen. Once the discrepancy has been corrected, auto-scan will
continue scanning the remaining channels and the centre section.
C C o o p p y y i i n n g g a a n n d d S S w w a a p p p p i i n n g g S S e e t t t t i i n n g g s s
Stored TR Setups can be copied or swapped between channels. The CS softkey is used to select the Copy/Swap
function between CS (no function), Copy and Swap. Once this button is in the appropriate state, hold down the
fader status button on the source channel and press the fader status button on the destination channel. The
source channel will be copied to (or swapped with) the destination channel.
Note that this function does not overwrite the original Total Recall data – changes are reflected in RAM only.
4 4 - - 6 6 D D u u a a l l i i t t y y S S E E O O p p e e r r a a t t o o r r ' ' s s M M a a n n u u a a l l