Solid State Logic Duality SE Operator's Manual page 160

A A u u t t o o m m a a t t i i o o n n
M M i i x x R R u u n n n n i i n n g g
Press Play on the DAW to move forward. Check that timecode on the screen matches that of the DAW — if
Duality SE is not reading MTC, it will not record any mix data.
Note that when doing the first Mix Pass, it is important to start the Pass at the beginning of the song/track.
As soon as the automation system has locked to the MIDI timecode (MTC), the mix status display will indicate 'Mix
Running'. Simply operate the faders and switches to write your Mix as required, and the fader moves and switch
data will be recorded. The DAW may be toggled freely between Stop and Play – if Fast Forward is used or the DAW
is located forward, the automation data will be extended to the new position when the DAW returns to Play.
To abort the current Mix at any time, press the Discard soft key or the dedicated DISCARD button in the
'AUTOMATION' group above the 'TRANSPORT' buttons. To save the current Mix to flash memory and return to
the Mix List, press the End softkey or the dedicated END button in the 'AUTOMATION' group. For more on the
other buttons in this group, see Dedicated Automation Buttons.
Mix Review
At any time you can rewind the system, and as soon as the DAW is located to an earlier time and valid MTC or a
MMC locate position command is received, the mix system enters 'Mix Review'. All faders will switch to Replay
status (all LEDs are off). This operation is known as a 'rollback'.
Mix Running: displayed while writing new automation data.
Mix Review: displayed when you replay previous automation data.
The number after Mix Review (in this case 23) indicates the number of times you have rolled back in the current
Mix.
When the DAW returns to Play, previously written automation data is replayed. Whilst in Mix Review you may
rollback as many times as required to allow the Mix to be built up fader by fader. Each time a rollback takes place,
the rollback counter in the mix status display increments. Faders in Write at a rollback point will automatically
switch to Write when the system plays through the rollback point.
5 5 - - 1 1 0 0 D D u u a a l l i i t t y y S S E E O O p p e e r r a a t t o o r r ' ' s s M M a a n n u u a a l l