Chapter 5 Programmer's Guide; Partition Table; Linux Tool Chain Introduction - Korenix JetBox 8100 User Manual

Chapter 5 Programmer's Guide

5.1 Partition Table

The Storage has been split into three partitions. To change the partitions,
you need to manually fdisk it.
Partition
/dev/hda1
/dev/hda2
/dev/hda3
Note.
1. The device name could be /dev/sdb due to the master/slave setting
on your Jetbox device.
2. The size of third partition variable according to different storage
type.

5.2 Linux Tool Chain Introduction

To ensure that an application will be able to run correctly when installed on
Jetbox, you must ensure that it is compiled and linked to the same libraries
that will be present on the Jetbox8100.
The host tool chain that comes with Jetbox8100 contains a suite of Korenix
compilers and other tools, as well as the libraries and headers that are
necessary to compile applications for Jetbox8100. The host environment
must be running Linux to install the Jetbox8100 GNU Tool Chain. We have
confirmed that the following Linux distributions can be used to install the
tool chain: Redhat 9.0, Fedora core 7.
The Tool Chain will need about 200 MB of hard disk space on your Linux
PC. The Jetbox8100 Tool Chain is located on the Jetbox8100 CD. To
install the Tool Chain, insert the CD into your PC and then issue the
following commands:
30
Size Contents
10MB Bootloader && Kernel
100MB Rootfs
1890MB~ Not in use
Table 5-1 Partition table
JetBox 8100 User Manaual_Linux_1.1