Telnet Console - Korenix JetBox 8100 User Manual

To log in, type the Login name and password as requested. The
default values as following.
Login: root
Password: none
In the JetBox 8100, COM1 (RS232) is reserved for serial console and
Notice 1:
COM2 (RS-232/422/485, JP2, BIOS select) is reserved for Modbus Gateway (Optional
SW).

2.2.2 Telnet Console

If you know IP addresses and netmasks, then you can use Telnet to
connect to JetBox 8100. The default IP address and Netmask for each
port is given below:
LAN
Use a cross-over Ethernet Cable to connect directly from your PC to
JetBox 8100. You should first modify your PC's IP address and
netmask so that your PC is on the same subnet as JetBox 8100.
To connect to a hub or switch connected to your local LAN, use a
straight-through Ethernet cable. The default IP address and netmasks
are shown above. To login, type the Login name and password as
requested. The default values as following:
Login: root
Password: none
6
Default IP address
192.168.10.1
Table 2-4 Default IP address and Netmask
Figure 2-5 Telnet console screen
Netmask
255.255.255.0
JetBox 8100 User Manaual_Linux_1.1