Parameters Setup Procedure - System Reset; Parameters Reset - Easson ES-12 Operation Manuals

A) Parameters Reset
Each ES-12 is configured as it leaves the factory, however, all parameters memory are backup by the
internal rechargable battery which can only last for 30 days after switched off. Therefore, if the DRO
have been powered off for more than 30 days, the ES-12 parameters might have to be reset or
reconfigured. Followings are the reset procedure for the ES-12.
Operating Procedure :
1) Switch off the ES-12
2) Switch on the ES-12, after switching on, with the software version no " VER. X-? " showing in the message
window, press the number "8" key to enter the parameter reset function.
DRO proceeds a self
test on electronics
circuit after switched on
with the software number displayed on the message windoow, for example, "VER. M-3"
press to enter into the reset function
3) After entered in the reset function, ES-12 will process a "RAM TEST" to test all RAM memory, and also
reset all RAM memory to 0. Finally, resume all factory default setting.
8888.8888
X
Y
8888.8888
Z 8888.8888
8888.8888
U
RAM TEST
DRO displays "RAM TEST"
means RAM test is in progress
X 8888.8888
Y 8888.8888
Z 8888.8888
8888.8888
U
RESET
DRO displays "RESET" means all parameters
have been resumed to factory default setting
4) Reset completed, the ES-12 will proceed LED display test until switch off.
X 8888.8888
Y
8888.8888
Z 8888.8888
8888.8888
U
ABS EASSON...

Parameters Setup Procedure - System Reset

Reset completed and ES-12 enters into a endless LED test to lest user know
if there is any missing segment in the LEDs, you can switched off the DRO
if you found no missing segment in the display LEDs
8888.8888
X
Y 8888.8888
8888.8888
Z
8888.8888
U
VER. X - ?
8888.8888
X
Y 8888.8888
8888.8888
Z
8888.8888
U
VER. M - 4
8888.8888
X
Y
8888.8888
Z 8888.8888
8888.8888
U
RAM OK
DRO displays "RAM OK" means
RAM memory tested OK
- B. 2 -
Software version