Power Supply Connection - Easson ES-12 Operation Manuals

2.2 POWER SUPPLY CONNECTION

Before connecting the electrical supply to the DRO, please check the VOLTAGE SELECTOR switch to
see if correctly main supply voltage selected or not. Check Figure below for the position of the switch.
The PROTECTIVE EARTH CIRCUIT of the mains supply MUST BE CONNECTED to the earth grounding terminal
of the DRO through the supply cord and connected through an earth cable as per shown in Page 1.
The supply cord must be secured with cable ties to avoid from dropping into a hazardous position, for example
the floor or coolant tray, when disconnected from the DRO.
The supply cord must be routed away from moving parts, swarf, coolant or sources of heat.
Power Switch
check if correct main
supply voltage is selected
Transducer Connectors
If a mains plug is not already fitted to the supply cord or is of the wrong type, then a suitable EARTHED plug
should be used which complies with the relevant specifications for plugs and socket-outlets.
The specification of the mains supply fuse is T0.5A, 220V. It can not be replaced by operator. If the fuse blows
it is a possible indication of some significant problem with the power source.
Check the supply and wiring carefully. When replacing the fuse, the DRO must be first disconnected by removal
of the IEC socket from the inlet. For this connector is the primary disconnect device, do not place the DRO in the
place where is difficult to reach and make sure that the plug must be accessible all the time.
NOTE: 1. If the DRO is used in a manner not specified by the manufacturer, the protection provided
by the equipment may be impaired.
2. Non-professionals do NOT open the cover or repair
POWER SUPPLY CONNECTION
Main Power
Power Switch
Fuse
Voltage Switch
Y Z
X
III
Earth Grounding Terminal
Grounding Terminal
Input Connectors
Figure 2.3