Parameters Setup Procedure - Rad/Dia - Easson ES-12 Operation Manuals

RAD/DIA menu is designed to allow operator to select the diemension display in Radius ( nromal display ) or
Diameteral ( 2X the real dimension ) display. This feature is very useful for lathe application. All axes in the DRO
can be configrured to DIA ( 2X ) display. If the axis display is configured as DIA display, a 'd' character will be
displayed at the first digit display of the axis to have the user easily recongise the display is in DIA mode. All
DRO functions that are normally used in lathe application are tested and confirmed to work properly under the
DIA display, such as INCL.
The RAD/DIA of the display axis are specified by 'rAd' or 'dIA' :
'rAd' - Radius mode display selected, axis shows the real dimension reading
'dIA' - Diameteral mode display selected, axis shows 2X( 2 times ) the real dimension reading.
Press to select the "RAD/DIA" selection menu
X
Y
Z
U
RAD/DIA
'rAd' represent Radius display mode, 'dIA' represent Diameter display mode. Press the "ent" key to make your selection
For example, if you want to make a change to the current 'rAd' display mode of the X axis, procedure are as follows
X
Y
Z
U
SEL.AXIS
Press or to specify the X axis, if the current display mode is 'rAd', it will swap to 'dIA' after the key
press, and vice versa. The same procedure applied to Y , Z and U axis
X
Y
Z
U
SEL.AXIS
then press
"RESOLU" menu and return to
the top level menu

Parameters Setup Procedure - RAD/DIA

rAd
rAd
rAd
rAd
dlA
rAd
rAd
rAd
to exist from
X
Y
Z
U
The 'rAd' display means Radius
display mode are selected in
the respective axis.
X
Y
Z
U
The X axis display mode have
been changed to Diameteral
display mode
X
Y
Z
U
RAD/DIA
- B. 11 -
rAd
rAd
rAd
rAd
SEL.AXIS
dlA
rAd
rAd
rAd
SEL.AXIS
selection done
go to next menu