Preparing For Online Removal Of A Sfp Or Xfp Modules - Cisco ASR 1000 Series Hardware Installation Manual

Chapter 3 Installing and Removing the Cisco ASR 1000 Series Fixed Ethernet Line Cards
Internal operational state
Physical insert detect time : 00:00:58 (03:19:08 ago)
Software declared up time
CPLD version
Firmware version
Preparing for Online Removal of SFP or XFP Modules
The Cisco ASR 1000 Series Aggregation Services Routers support OIR of an SFP or XFP module
without removing the Cisco ASR 1000 Series Fixed Ethernet Line Card. This means that a Cisco ASR
1000 Series Fixed Ethernet Line Card can remain installed in the router with one XFP remaining active,
while you remove another XFP from one of the line-card ports, or that a Cisco ASR 1000 Series Fixed
Ethernet Line Card can remain installed in the router with some number of SFP modules remaining
active, while you remove other SFP modules from the line-card ports.
The interface configuration is retained or recalled if a Cisco ASR 1000 Series Fixed Ethernet Line Card
or SFP or XFP is removed and then replaced with one of the same type.
However, if the line card is already installed in the router and the system is operational, we recommend
that you shut down the port using the interface config command before removing the SFP or XFP
modules.
OL-29623-03
: ok
: 00:01:51 (03:18:15 ago)
: 00200800
: 15.2(1r)S
Cisco ASR 1000 Fixed Ethernet Line Card Hardware Installation Guide
Online Insertion and Removal
3-33