Connectors And Cabling - Cisco ASR 1000 Series Hardware Installation Manual

Chapter 1 Overview of the Cisco ASR 1000 Series Fixed Ethernet Line Card
•
•
The following SFP modules are supported:
•
•
•
•
Note
•
•
•
•
•
•
•
•
•
•
•
Connectors and Cabling for SFP Modules
The SFP optical transceiver module on the Cisco ASR 1000 Series Fixed Ethernet Line Card requires
dual or single LC and PC connectors. Only connections with patch cords having PC or UPC connectors
are supported. Patch cords with APC connectors are not supported. All cables and cable assemblies used
must be compliant with the standards specified here:
•
•
•
For single-mode and multimode optical fiber connections, you can use either a
and Connector
OL-29623-03
EXT—Extended operating temperature range from -5 to 85 degrees C (23 to 185 degrees F)
IND—Industrial operating temperature range from -40 to 85 degrees C (-40 to 85 degrees F)
SFP-GE-S
SFP-GE-L
SFP-GE-Z
SFP-GE-T
For Cisco IOS XE Release 3.10, SFP-GE-T= is supported only in the 1 Gbps mode.
GLC-BX-D
GLC-BX-U
GLC-LH-SMD
GLC-SX-MMD
GLC-EX-SMD
GLC-ZX-SMD
GLC-GE-100FX, supported effective from Cisco IOS XE Release 3.13S
GLC-TE, supported effective from Cisco IOS XE Release 3.15S
DWDM
CWDM
GLC-GE-100FX
GR-20-CORE—Generic Requirements for Optical Fiber and Optical Fiber Cable
GR-326-CORE—Generic Requirements for Single-mode Optical Connectors and Jumper
Assemblies
GR-1435-CORE—Generic Requirements for Multi-Fiber Optical Connectors
or two simplex LC-type cables, one for transmit (TX) and one for receive (RX).
Cisco ASR 1000 Fixed Ethernet Line Card Hardware Installation Guide
Modular Optics Compatibility
Duplex LC-Type Cable
1-11