Slide Tab Sfp Module; Removing A Slide Tab Sfp Module - Cisco ASR 1000 Series Hardware Installation Manual

Removing and Installing SFP Modules
Figure 5-9
Note
Verify that the SFP modules are completely seated and secured in their assigned receptacles on the line
card by firmly pushing on each SFP module. If the SFP module is not completely seated and secured in
the receptacle, you will hear a click as the triangular pin at the bottom of the SFP module snaps into the
hole in the receptacle.

Slide Tab SFP Module

The slide tab SFP module has a tab underneath the front of the SFP module. Use the tab to disengage the
module from a port. (See
Figure 5-10

Removing a Slide Tab SFP Module

To remove this type of SFP module, follow these steps:
Step 1
Attach an ESD-preventive wrist strap or ankle strap according to the instructions provided.
Step 2
Disconnect and remove all the interface cables from the ports; note the current connections of the cables
to the ports on the line card.
Step 3
Grasp the SFP module between your thumb and index finger.
Step 4
With your thumb, push the slide tab at the bottom front of the SFP module in the direction of the line
card to disengage the module from the line card port. (See
Cisco ASR 1000 Fixed Ethernet Line Card Hardware Installation Guide
4-42
Installing an Actuator Button SFP Module
Figure 5-10.)
Slide Tab SFP Module
Chapter 4 Installing and Removing the SFP and XFP Modules
Figure 5-11.)
OL-29623-03