Actuator Button Sfp Module; Removing An Actuator Button Sfp Module - Cisco ASR 1000 Series Hardware Installation Manual

Removing and Installing SFP Modules
Note
Verify that the SFP modules are completely seated and secured in their assigned receptacles on the line
card by firmly pushing on each SFP module. If the SFP module is not completely seated and secured in
the receptacle, you will hear a click as the triangular pin at the bottom of the SFP module snaps into the
hole in the receptacle.

Actuator Button SFP Module

The actuator button SFP module includes a button that you should push in order to remove the SFP
module from a port. (See
Figure 5-7

Removing an Actuator Button SFP Module

To remove this type of SFP module, follow these steps:
Step 1
Attach an ESD-preventive wrist strap or ankle strap according to the instructions provided.
Step 2
Disconnect and remove all the interface cables from the ports; note the current connections of the cables
to the ports on the line card.
Step 3
Gently press the actuator button on the front of the SFP module until it clicks and the latch mechanism
is activated, releasing the SFP module from the port. (See
Cisco ASR 1000 Fixed Ethernet Line Card Hardware Installation Guide
4-40
Figure 5-7.)
Actuator Button SFP Module
Chapter 4 Installing and Removing the SFP and XFP Modules
Figure 5-8.)
OL-29623-03