Global Torque Alarm; Instructions For Global Torque Alarm Setup; Global Torque Action; To Reset Global Torque Alarm - Magtrol DSP7000 User Manual

Chapter 5 – Alarm System
5.6

global torque alarm

5.6.1 i
nSTruCTionS for
1. Starting from main menu, press ShIFT.
2. Press SETUP button.
3. Select TANDEM.
4. Press SCALE I button to select "YES" and then press ShIFT.
NoTE:
5. Press MAx SPEED button and use  and  buttons and Decrease/Increase dial to set
desired global torque value.
6. Press ShIFT 2 times to complete global Torque Alarm setup and return to the main menu.
5.6.2 g T
loBal
If torque is greater than the maximum setting the display will flash "gLobAL ToRqUE ALARM"
(as indicated in Figure 5–9) The alarm relay will open, excitation current will hold at last value for
3 seconds then drop to zero. Standby signal is not cycled
5.6.3 T r
o eSeT
Press any front panel button other than ShIFT. If the alarm condition is clear, the unit will return
to normal operation. Although not recommended, another option would be to disable the alarm by
following the alarm setup instructions in Section 5.6.1 – Instructions for Global Torque Alarm Setup.
5.7

air flow alarm

• Used to indicate a lack of air flow from a blower or air line
• Only for use with Hysteresis Dynamometers
• Monitored only when the brake is ON
• Default is set in "OFF" mode
5.7.1 i
nSTruCTionS for
1. Starting from main menu, press ShIFT.
2. Press SETUP button.
3. Select DYNo.
4. Select ALARMS. The display should appear as follows:
g T a
loBal orque
POWER TORQUE
GLOBAL POWER
XXX.XXKW
BRAKE STATUS SET POINT
Figure 5 –16 Global Torque Alarm Setup
global torque alarm is only enabled when Wb/Wb or Pb/Pb dyno
tandem configuration.
a
orque CTion
g T a
loBal orque larM
a f a
ir low larM
Magtrol Model DSP7000 Dynamometer Controller
S
larM eTup
SPEED
TORQUE
XXX.XX Nm
SET POINT
S
eTup
52
USER DISPLAY
ALARMS
P I D