Any other use should be considered incorrect and therefore dangerous. Do not use any accessories other than those recommended by Technogym. Never operate the product if it has a damaged cable or plug, if it is not working correctly, if it has been knocked over or damaged, or if it has fallen into water. In these circumstances, contact the Technogym Technical Support Service.
Page 4
To disconnect power, turn all controls to the off position, then remove the plug from the outlet. SAVE THESE INSTRUCTIONS Warnings Do not connect a device with load exceeding 7A. Risk of electric shock. Do not disconnect under load. Do not connect to a circuit operating at more than 150V to Ground. CLIMB ARTIS...
Do not attempt any maintenance work on the product other than the operations described in the user manual. The installation, maintenance and setting operations must be carried out by qualified Technogym staff or persons authorised by Technogym. The electrical system must conform to the standards and legal requirements in the country of use.
Page 6
Technogym’s written authorisation or for failure on your part to use, operate and maintain the product as set out in this User Manual.
The values stated in the illustration are purely indicative; refer to the label attached to the product or the data in the “Technical characteristics” section for the correct information. Technogym S.p.A. via Calcinaro 2861, Cesena (FC) Made in Italy CLIMB ARTIS Model no.
Display (A). It allows you to view and control information, settings and contents both for workouts and for entertainment. The tablet-style touch screen interface allows you to include the contents offered by the Technogym App Store. Side hand grips (B). They provide stable support when getting on or off the product or losing balance.
Keep a constant check on your posture: head held high, shoulders in line with your hips, stomach pulled in and chest raised. Warning Any distractions in the area around the equipment may cause the user to lose his/her balance. CLIMB ARTIS...
Page 10
To get off the device in an emergency, grasp the side handgrips, support your weight on them and move your feet onto the footrests. Then get off the equipment. Climb is designed solely for the use it was designed and manufactured for, as a stair simulator. Any other use of the equipment is to be considered improper and therefore dangerous. CLIMB ARTIS...
The heart rate shown on the display is purely indicative and cannot be considered absolutely certain. Do not use the heart rate monitor if you have a cardiac support device such as a pacemaker or similar. CLIMB ARTIS...
Page 12
Combined use of fats and sugars. Significant improvement of aerobic efficiency. Prevalent use of fats and increased use of sugars. Moderate improvement of aerobic efficiency. Prevalent use of fats and little use of sugars. Limited improvement of aerobic efficiency. CLIMB ARTIS...
Time 0÷999 min ± 1% Maximum capacity of water bottle-holder 2 kg (4 lb) Distance 0÷9999 floors ± 5% Protection grade IP 20 Electric isolation class Class I 770 mm (30") 1300 mm (51") 470 mm (19") CLIMB ARTIS...
START button on the display. The START button is enabled only if the sensor area is clear. The label (F) near the main switch provides electrical specifications . Please read the adhesive labels on the product, which provide information about possible risks and hazards. CLIMB ARTIS...
Do not use the product outside. Do not use the product outdoors, where it is exposed to the elements. Ensure that the product does not get splashed by water. Do not place the product in locations with high moisture levels, such as swimming pools, whirlpool tubs and saunas. Do not operate where aerosol (spray) products are being used or where oxygen is being administered. CLIMB ARTIS...
If wheels cannot be used on the floor, move the equipment with normal lifting and transport methods. Warnings Move the product very carefully, because it could become unstable and tip over. Do not lift or move the product from the steps or display. CLIMB ARTIS...
LEVELLING In order to function correctly, the product must be level. The product is levelled by adjusting the two fixed feet. Remove the lower guard (B). Remove the side guard (C). CLIMB ARTIS...
Page 18
Screw the front feet (E) in or out until the frame is in a stable position. Tighten up the lock nut (D) after adjusting. Reposition the side guard (C), applying pressure. Reposition the lower guard (B), applying pressure. CLIMB ARTIS...
The wall socket must be located in a place where the plugging and unplugging can be done easily and safely. When plugging in, the power supply switch must be in the 0 position (the equipment must be switched off). Check the state of the power supply cable periodically. CLIMB ARTIS...
Page 20
Do not modify the plug provided with the product; if it will not fit in the outlet, have a proper outlet installed by a qualified electrician. CLIMB ARTIS...
Use an RF coaxial cable to connect the antenna with an F-type connector for the product. The wall socket for the antenna cable must be located in a position where the plug can be inserted and removed with ease. CLIMB ARTIS...
Warnings The switch turns the product on/off but it does not isolate it from the mains voltage, even if it is in position “0” (off). Take the power plug out of the socket to isolate the product. CLIMB ARTIS...
Move the step downwards, to the position shown in the illustration. Apply oil to every opening in the hinge. Repeat for each of the 8 steps. Warning Before placing the product back in service, remove any excess lubricant from the surface of the steps with a cloth. CLIMB ARTIS...
Page 24
Replace defective or worn components immediately, or remove the product from service. The routine maintenance, adjustment and lubrication jobs must be performed by the Technogym Technical Support Service. Before starting any job, turn the equipment off by switching the switch to the 0 position and unplug the power cable from the wall socket.
After installation of the Climb product, transmission parts (belts, chains) must be replaced every 3 years. If the buyer fails to replace these components, Technogym will be discharged from any liability for bodily injury or property damage arising out of the malfunction of the product’s transmission unit.
Contact the Technogym Technical Support Service. The product is not turning ON The power supply cable is not correctly inserted. Check the connection. To replace the blown fuse with a spare contact Technogym Burnt-out fuses Technical Support Service. The product is not level.
Via Calcinaro 2861, 47521 Cesena Italy on-site servicing tel: +39 0547 56047 supply of original spare parts. http://www.technogym.com/Support When you contact the Technogym Technical Support Service you must give the following information: Product model (A) Date of purchase Serial number (B) Technogym S.p.A.
If the product is used for commercial purposes, contact your reseller or the Technogym Customer Service, in the various Countries, to arrange for collection and disposal of waste from electrical and electronic equipment.