Qx82-S1 Dc Input Module (Negative Common Type) - Mitsubishi QX10 User Manual

2 INPUT MODULE SPECIFICATIONS

2.24 QX82-S1 DC Input Module (Negative Common Type)

Specifications
Number of input points
Isolation method
Rated input voltage
Rated input current
Input derating
ON voltage/ON current
OFF voltage/OFF current
Input impedance
Set value
Response OFF to ON
time
ON to OFF
Dielectric withstand voltage
Insulation resistance
Noise immunity
Protection degree
Common terminal arrangement
Number of occupied I/O points
Operation indicator
External connections
Applicable wire size
Applicable connector
Applicable connector/terminal
block converter module
Internal current consumption
(5VDC)
Weight
1: Configured in PLC parameter. (Default: 0.2ms)
A response time setting value can be changed in GX Developer (SW5D5C-GPPW or later).
For the setting method, refer to Section 1.3.1.
2 : When using A6CON2 or A6CON3, refer to Chapter 7.
2 - 32
Type
24VDC (+20/-15%, ripple ratio within 5%)
1 0.1
TYP. 0.05ms 0.15ms
MAX. 0.12ms 0.20ms
TYP. 0.15ms 0.20ms
MAX. 0.20ms 0.30ms
560VAC rms/3 cycles (altitude 2000m)
10MΩ or more by insulation resistance tester
By noise simulator of 500Vp-p noise voltage, 1
First transient noise IEC61000-4-4: 1kV
32 points/common (common terminal: 1B01, 1B02, 2B01, 2B02)
64 points (I/O assignment is set as a 64-point high-speed input module.)
ON indication (LED), 32 point switch-over using switch
0.088 to 0.3mm
A6CON1, A6CON2, A6CON3, A6CON4 (optional)
DC input module (Negative common type)
QX82-S1
64 points
Photocoupler
Approx. 4mA
Refer to the derating chart.
19V or higher/3.0mA or higher
9.5V or lower/1.5mA or lower
Approx. 5.6kΩ
0.2 0.4
0.30ms
0.40ms
0.35ms
0.50ms
and 25 to 60Hz noise frequency
IP2X
40-pin connector
(For A6CON1 or A6CON4)
2
—————
90mA (TYP. all points ON)
0.18kg
0.6 1
0.55ms 1.05ms
0.60ms 1.20ms
0.60ms 1.10ms
0.70ms 1.30ms
s noise width
2
MELSEC-Q
Appearance
QX82-S1
0 1 2 3 4 5 6 7
8 9 A B C D E F
0 1 2 3 4 5 6 7
8 9 A B C D E F
QX82-S1
DISPLAY
24VDC
F L
4mA
2 - 32