Creating A Drive Object; Overview - Siemens Sinamics S120 Getting Started

Creating a drive object

5.1

Overview

This example shows how you can generate a new drive project using the STARTER
commissioning tool. You then transfer the drive project via a communication interface to the
Control Unit of the drive.
For data exchange between the programming device (PG/PC) and the Control Unit (CU), an
Ethernet interface is used in the example, which is integrated into each SINAMICS S120
device. With PROFIBUS or PROFINET interfaces, commissioning happens in a similar way.
The programming device and the drive (in the training case example) are switched on and
connected to each other via a data line.
Getting Started
Getting Started, (GS1) 04/2014, 6SL3097-4AG00-0BP3
5
29