Nokia Ip40 Security Platform Front Panel - Nokia IP40 User Manual

1
Introduction
Table 9 Rear Panel of IP40
Label
Console
Reset
Note
Do not use a sharp pin or thin piece of metal to press the Reset button.

Nokia IP40 Security Platform Front Panel

You can monitor the IP40 operations by viewing the LEDs on the front panel.
Figure 2 Front Panel of Nokia IP40 Security platform.
The items on the front panel of the Nokia IP40 Security Platform are explained in
page 35.
34
Description
The console port is a 9-pin male connector that can be
connected to the serial (COM) port of your computer.
You can then use the command-line interface (CLI) of
the IP40 through a serial program such as
HyperTerminal to communicate with the device.
Used to reboot or reset the IP40 to its factory defaults.
Use a large flat-tipped object, such as a thick paper
clip, to press the reset button.
Short press (one second): reboots the Nokia IP40
Security Platform.
Long press (seven seconds): resets the IP40 to its
factory defaults. This results in loss of all security
services and passwords.
Short press during boot up: boots the IP40 in special
deployment mode. See "Resetting Nokia IP40 Security
Platform to Factory Defaults" on page 188.
Nokia IP40 Security Platform User's Guide v2.0
Table 10 on