Power Supply Fans; Figure 5-4 Removing The Power Supply Fans - Compaq PowerStorm 1000 Owner's Manual

5.6 Power Supply Fans

Perform the following procedure to remove the power supply fans from the PowerStorm
1000 graphics subsystem deskside chassis:
1. Perform a normal system power down (see Section 5.2).
2. Remove the front bezel (see Section 5.3).
3. Remove the two screws
which the power supply fans are mounted and tilt the top of the access panel away
from the chassis (see Figure 5-4).
4. Disconnect the two fan power connectors
5. Lift the power supply access panel until the tabs at the bottom of the access panel
come out of the slots at the bottom front of the chassis and remove the access panel.
6. Remove the four screws
power supply access panel (see Figure 5-4).
To replace the power supply fans, reverse steps 1 through 6 of the removal procedure.

Figure 5-4 Removing the Power Supply Fans

4
c
that secure the top of the power supply access panel in
š
› œ
and nuts that secure the failing fan to the inside of the
3
2
4
DIGITAL PowerStorm 1000 Graphics Subsystem Owner's Guide 5–7
Removal and Replacement
(see Figure 5-4).
1
ML014214