Led Behavior - HP procurve 420 Getting Started Manual

Installing the Access Point 420
Installation Procedures
2.

LED Behavior:

2-6
Check the LEDs on the access point as described below.
hp procurve
wireless
access point
420
Power LED
When the access point is powered on, it performs its diagnostic self test.
The self test takes approximately 50 seconds to complete.
During the self test:
• The 10/100Base-TX and Wireless LEDs go off and then may come on
again during phases of the self test. For the duration of the self test,
the Power LED blinks.
When the self test completes successfully:
• The Power LED remains on.
The 10/100Base-TX and Wireless LEDs on the top of the access point
•
go into their normal operational mode:
– If the ports are connected to active network devices, the LEDs
should be on.
– If the ports are not connected to active network devices, the LEDs
stay off.
If the LED display is different than what is described above, especially if
the Power LED does not stop blinking, the self test has not completed
correctly. Refer to chapter 5, "Troubleshooting" for diagnostic help.
Link/Activity
Power 10/100-TX Wireless
Ethernet LED
Wireless LED