Notes - Axminster TS-200-2 Assembly Instructions Manual

Code
Model
Rating
Power
Blade Dia/Bore
Blade Tilt
Max Depth of Cut @ 45˚
Max Depth of Cut @ 90˚
Max Width of Cut with Fence
Table Size
Table Height
Dust Extraction Outlet
Min Extraction Airfl ow Required
Overall L x W x H
Weight
Stand Assembly
1. Locate and identify the four leg "A" frames (H),
the long struts (I) and the short struts (J) for the
stand, and the packet containing 32 M8 x 16mm
coach bolts, washers and nuts,(L1).
2. Using the M8 x 10mm coach bolts, nuts and
washers bolt together two 'A' frames using two
legs (H) one long strut (I) in the middle and one
short strut (J) at the top. 'fi nger tighten' the nuts
only at this time, see fi g 1.
3. When the two 'A' frames have been assembled,
select one, turn it upside down on a fl at surface
and loosely bolt the 'short struts' (J) and long struts
(I) in place, see fi g 2. Attach the other "A' frame and
loosely tighten.
4. When all the components are
assembled, turn the stand over
and place the four rubber feet
(K) to the ends of the 'A' frames.
(See fi g 3) Upright the frame
and stand on the fl oor, see
fi g 4.
NOTE: GO ROUND THE
FRAME AND FINGER
TIGHTEN THE NUTS AT
THIS POINT!
508310
TS-200-2 Basic
Hobby
1.1kW 230V, 1ph
205mm/30mm
0° to 45°
40mm
60mm
190mm standard,
750mm with R/H Table Kit
675 x 400mm
320mm
100mm
500m³/hr
800 x 400 x470mm
55kg
Fig 01
Fig 04
Code
Model
Rating
Power
Blade Dia/Bore
Blade Tilt
Max Depth of Cut @ 45˚
Max Depth of Cut @ 90˚
Max Width of Cut with Fence
Table Size
Table Height
Dust Extraction Outlet
Min Extraction Airfl ow Required
Overall L x W x H
Weight
I
J
H
Fig 02
Fig 03
9
Specifi cation
TS-250M-2 Basic
1.5kW 230V 1ph
250mm/30mm
200mm standard
760mm with R/H Table Kit
670 x 430mm
920 x 560 x 560mm
Assembly
I
K
508312
Hobby
0° to 45°
60mm
76mm
360mm
100mm
750m³/hr
80kg
L1
J