Axminster TS-200-2 Assembly Instructions Manual page 28

Setup and Adjustment
Setting the Blade Alignment
If the blade is not cutting 100% true, the blade is out
of alignment. Follow the instructions below on how
to set the blade to the table.
1. Remove the blade crown guard and table insert,
see fi g 93.
2. Loosen the four Hex screws (A), see fi gs 93-94.
3. Place a steel rule up-against one end of the blade
and take a measurement to the 'T' slots edge, see fi g
95.
Fig 93-94
A
Fig 95
Table 'T' slot
Table insert
Steel rule
4. Place the rule to the opposite end of the blade
and take a further reading, see fi g 96.
6. If there is any deviation between the
measurements,adjust the blade assembly by
moving each end on its rails (B) (beneath the table),
see fi gs 97-98, until both ends of the blade are the
same distance away from the 'T' slot edge.
7. Tighten the four Hex scews (A).
8. Replace the blade guard and table insert.
A
Blade rail
Blade assembly
A
28
B
Fig 96
Fig 97-98