Axminster TS-200-2 Assembly Instructions Manual page 10

Assembly
Mounting the Saw Bench to the Stand
1. With
assistance,
place the Saw
Bench (A) onto
the stand. Align
the four mounting holes at
the base of the saw bench
with the four mounting
holes at each corner of
the stand. Using four M8
x 16mm hex bolts, large
washers & nuts (L2) secure
the saw bench to the
stand, see fi gs 05-06. Now
tighten all the nuts on the
stand assembly.
2. Locate the yellow kerf plate and four Phillips
screws and secure it into the tables recess, see fi g 7.
Fig 07
Basic Saw
1. Locate the two operating wheel handles (G6) and,
using the supplied 3mm Hex key (G4), secure one to
the height mechanism shaft to the front of the saw
by undoing the grub screw on the operating wheel
handle (G6) and sliding it onto the shaft, making sure
the grub screw is in line with machined slot (a), in the
shaft. Retighten the grub screw. Repeat for the tilt
mechanism to the right hand side of the saw.
Fig A
a
Fig 05
A
L2
Height mechanism shaft
G6
Tilt mechanism shaft
2. Slide the mitre fence (D) into one of the tables 'T'
slots, see fi g 08.
3. Remove the table inset, place safely aside and
raise the saw blade to its maximum height,
see fi g 09.
D
4. Locate the riving knife (A1). Loosen the two nuts
holding the riving knife clamping plates, slide the
riving knife down between the two plates and lightly
tighten to hold the riving knife in place. Check that
the tip of the knife has a clearance of 3-8mm
between the blade then tighten the nuts to secure
the riving knife in place, see fi gs 10-11-12.
Clamping plate
3-8mm Gap between the
riving knife and the blade
10 10
Fig B
Fig 08-09
Table insert
Fig 10-11-12
A1
A1