Axminster TS-200-2 Assembly Instructions Manual page 11

5. Locate the crown guard and fl exible hose (B).
Remove the clamping pin bolt, washer and lift and
shift handle from the crown guard assembly, slot the
guard down over the riving knife (A1) until the holes
are in line then replace the pin bolt, washer and
clamping handle, see fi gs 13-14.
Fig 13-14
6. Locate the table insert height shims (A2), place
a shim over the pre-drilled holes in the table insert
recess place the insert on top and check its level
with the main table, see fi g 15-16. Add extra shims if
required.
Fig 15-16
Pin bolt
B
Lift & shift handle
A2
7. Remove the three nuts and washer from the fence
rail (F) and place safely aside. Slot the threaded bolts
in the fence rail through the three pre-drilled holes
to the front of table, replace the washers/nuts and
lightly tighten, see fi g 17-18.
F
8. Lift up the clamping handle on the rip fence
assembly (E) and slide the fence onto the fence rail
(F), see fi g 19.
F
11
Assembly
Fig 17
Fig 19
E
Continues Over...