Notes - Axminster TS-200-2 Assembly Instructions Manual

Micro Adjuster (TS-250M-2 ONLY)
12. Locate the micro adjuster (A3), remove the end
cap from the rip fence assembly (E), see fi g 28. Insert
the mounting blocks on the micro adjuster (A3) into
the 'T' slot to the side of the rip fence assembly. Line
up the drive pinion with rack and using the supplied
Phillips screwdriver secure the micro adjuster to
the underside of the fence assembly, see fi g 29-30.
Replace the end cap.
NOTE: Make sure the teeth of the pinion
engages into the rack.
Fig 28-29-30
End cap
'T' Slot
A3
Mounting blocks
13. Lift up the fence clamping handle, push in and
turn the control knob on the micro adjuster (A3) and
check it tracks smoothly down the fence rail (F), see
fi g 31.
14. Locate the dust extraction moulding (C). Remove
the four Phillips screws and washers around the
extraction outlet, line up the holes in the dust
extraction moulding with the threaded holes to
the side of the saw and secure in position with
the screws you removed earlier, see fi g 32-33.
Extraction outlet
Phillips screw
C
13
Assembly
Fig 31
Control knob
Fig 32-33
Continues Over...