Axminster TS-200-2 Assembly Instructions Manual page 17

12. Replace the rip fence assembly (E) onto the
front fence rail (F). Remove the short rip fence from
the main assembly by removing the four cap head
screws, place safely aside, see fi g 54-55.
Fig 54-55
13. Locate the long rip fence
(N), insert the guide bearing
into the rear guide rail (O), see fi g 56 align the four
holes to the opposite end with the holes in the main
clamping assembly and replace the cap head screws,
securely tighten with the Hex key, see fi g 57.
Fig 56-57
N
Guide bearing
14. Move the fence (E) until it's in line with the table's
'T' slot, if the fence is out of alignment loosen the four
cap head screws on top of the rip fence assembly, see
fi g 57 and adjust the fence until its in alignment,
re-tighten the cap head screws.
15. Remove the rip fence extension from the short
rip fence assembly and attach it to the long rip fence
(N) as described on step 10 on page 12.
16. Slide the rip fence assembly (E) up against
the blade and check the index marker on the
magnifying glass reads 'zero' on the scale. If
adjustment is required loosen the fi xings only on
the front fence rail and lightly tap the end of the
rail until the marker reads 'zero' on the scale.
Cap head screws
17. Replace hose support bracket (A4) to the far
corner of the extension table and hook the fl exible
O
hose over he bracket, see fi g 57.
Sliding Table Kit
1. Position one carriage support arm (V) to the
underside of the cast iron saw bench (A), line up
the clearance holes (a) in the support arm with the
pre-drilled holes in the table, using four M6 x 45mm
countersink heads and nuts, (W2) secure the support
arm to the table using a 4mm Hex key (G4), see fi gs
58-59-60. Repeat for the remaining arm.
17
ONLY LIGHTLY LOOSEN THE
FRONT FENCE RAIL THEN TAP
THE END UNTIL THE MARKER
READS 'ZERO' ON THE SCALE.
NOTE: PLACE A STRAIGHT EDGE
ACROSS THE FRONT EDGE OF THE
TABLES AND CHECK THEY ARE
STILL LEVEL AND ADJUST UNTIL
CORRECT.
Assembly
A4
Continues Over...