Drier Operation Modes - Axis AGS200/T250 User Manual

USER MANUAL
15

11.2 Drier operation modes

During the balance – drier operation sampling of the mass on the pan takes place.
Sampling time is set by the user, according to drying process speed. As a result of
sampling the current humidity value is calculated and displayed. Measurement is
finished depending on selected Drying mode:
1. In Time mode total humidity measurement time (Drying time) is defined by the user,
2. In Short mode humidity measurement is finished, when drying is stopped and
differences of a few successive mass samples are smaller than threshold value (2 mg).
Amount of successive samples taken into consideration is defined as Samples quantity.
Measurement is finished when Drying time is exceeded at the latest.
Stop
m
<2mg
>2mg
Start
Ts
t
Qualifying amount
(3 samples)
Drying chart in Short mode for Samples quantity = 3.