Table of Contents
Advertisement
4.
Remove the WLAN module (4) by pulling the module away from the slot at an angle.
5.
If the WLAN antenna is not connected to the terminal on the WLAN module, install a protective
sleeve on the antenna connector, as shown in the following illustration.
To replace the WLAN module, reverse the removal procedures.
NOTE:
The WLAN module is designed with a notch to prevent incorrect insertion.
Connector board cable
To remove the connector board cable, use this procedure and illustration.
Table 5-6
Connector board cable description and part number
Description
Connector board cable
Before removing the connector board cable, follow these steps:
Spare part number
N94774-001
Connector board cable
41
Advertisement
Table of Contents
