Etac Prio Manual page 34

Etac / Prio / www.etac.com
5. Remove the rear wheels (not 16"). Remove one
armrest and lock the backrest angle using an
Allen key or similar (later adjust the backrest
angle to align correctly with the hole).
6. Lie the chair down on its "back". Loosen the
screw next to the gas piston's front attachment.
7. Loosen the screws on the side plates by approx.
1-2 turns. Loosen and remove the screws which
hold the side plates in place. Support the back
chassis while the screws are loosened. This will
prevent the gas piston being damaged. Reposi-
5
6
7
6. Settings
Seat depth
tion to the desired seat depth, insert and tighten
the screws (see "Screw positions for seat depth"
diagrams).
Risk of tipping: Always check the setting of the
the anti-tips.
34
13 mm 5 mm