List Of Outputs - SMC Networks PF2A712H Operation Manual

■List of outputs

Find the diagram of the output required in the table below. Perform settings following the Set value column
on the right.
Switch output diagram
1: Hysteresis can be set between "0" and "3% of maximum rated flow". If the difference between Set point 1 and Set point 2 is less than
"6% of maximum rated flow", the maximum Set value of hysteresis is (Set point 1 - Set point 2) divided by 2.
2: When Set point 1 = Set point 2, chattering may occur.
Switch
Output mode
operation
Non-Reverse
output
Instantaneous
output mode
Reverse output
Non-Reverse
output
Accumulated
output mode
Reverse output
Non-Reverse
output
Accumulated
pulse output
mode
Reverse output
-19-
Set value
Set point 2 Set point 1
≦
Hysteresis mode
Set point 1 Set point 2
＜
Window comparator mode
Set point 2 Set point 1
≦
Hysteresis mode
Set point 1 Set point 2
＜
Window comparator mode
Upper digits
Middle digits
Lower digits
Upper digits
Middle digits
Lower digits
No Set value input
No Set value input
No.PF※※-OMG0010-G
2
2