Configure The Application - Fagor 8065 M Manual

P a n e l P C .
5.3

Configure the application.

The "Configuration" button at the top shows the window to configure the connection to the
CNC.
When the application starts, it displays the current configuration saved in the
FagorConnect.ini file. The configuration is saved in this file when the "Save Configuration"
or "Connect" buttons are pressed; it is not saved automatically when the application is closed.
The FagorConnect.ini file is saved between shutdowns, regardless of the Panel PC mode
(user mode or administrator mode).
The "Reset Configuration" button resets the default values of the parameters. The
application will request confirmation to perform this action.
Main window parameters:
Parameter.
CNC Name / IP address.
User.
Password.
Connect On Startup.
Timeout.
Full Screen.
Screen Size.
Screen Position.
Win Exit
Log file
Meaning.
Name or IP address of the CNC to which you wish to connect
the Panel PC.
By default, it is CNC8070.
Username for connection to the CNC.
By default, it is CNC8070.
Password to validate the connection to the CNC.
By default, it is CNC8070.
Es ta b l i s h t h e c o n ne c t i o n t o th e C N C w h en s ta r t i n g
FagorConnect.
By default; No.
Maximum time to attempt to establish the connection with the
CNC.
By default; 180 seconds.
Open the Remote Desktop application in full screen mode.
By default; Yes.
Size of the Remote Desktop window (only when the Full Screen
parameter is set to "No"). The maximum and minimum values
are 1920×1080 and 1024×768.
By default: 1024×768 pixels.
Position of the Remote Desktop window (only when the Full
Screen parameter is set to "No").
By default: 0.0 pixels.
Not used.
Not used.
5.
CNC 8065
(R : 1801)
EF
·87·