Safety Conditions - Fagor 8065 M Manual

SAFETY CONDITIONS

Read the following safety measures in order to prevent harming people or damage to this product and those
products connected to it. Fagor Automation shall not be held responsible of any physical or material damage
originated from not complying with these basic safety rules.
Before start-up, verify that the machine that integrates this CNC meets the 2006/42/EC Directive.
PRECAUTIONS BEFORE CLEANING THE UNIT
Do not get into the inside of the unit.
Do not handle the connectors with the unit
connected to AC power.
In case of a malfunction or failure, disconnect it and call the technical service.
Do not get into the inside of the unit.
Do not handle the connectors with the unit
connected to AC power.
PRECAUTIONS AGAINST PERSONAL HARM
Interconnection of modules.
Use proper cables.
Avoid electric shocks.
Ground connection.
Do not work in humid environments.
Do not work in explosive environments.
Only personnel authorized by Fagor Automation may access the
interior of this unit.
Before handling these connectors (I/O, feedback, etc.), make sure
that the unit is not powered.
PRECAUTIONS DURING REPAIRS
Only personnel authorized by Fagor Automation may access the
interior of this unit.
Before handling these connectors (I/O, feedback, etc.), make sure
that the unit is not powered.
Use the connection cables provided with the unit.
To prevent risks, only use cables and Sercos fiber recommended for
this unit.
To prevent a risk of electrical shock at the central unit, use the proper
connector (supplied by Fagor); use a three-prong power cable (one
of them being ground).
To prevent electrical shock and fire risk, do not apply electrical voltage
out of the indicated range.
In order to avoid electrical discharges, connect the ground terminals
of all the modules to the main ground terminal. Also, before
connecting the inputs and outputs of this product, make sure that the
ground connection has been done.
In order to avoid electrical shock, before turning the unit on verify that
the ground connection is properly made.
In order to avoid electrical discharges, always work with a relative
humidity (non-condensing).
In order to avoid risks, harm or damages, do not work in explosive
environments.
Pa ne l P C.
CNC 8065
(R : 1801)
EF
·13·