Auriol Z31915 Operation And Safety Notes page 15

Connecting the weather station with the outdoor sensor and the
DCF radio signal:
After removal of the battery safety strip the weather station attempts to establish a
connection with the outdoor sensor. This process can take a few minutes. The symbol
will keep flashing for few minutes. On successful connection with the outdoor sensor,
the selected channel symbol appears in the LC display with the channel of the
27
outdoor sensor (if necessary you can change the channel of the outdoor sensor as
shown in the section "Setting the channel"). If the connection with the outdoor sen-
sor is not established automatically, this can be done manually as follows:
1. Press the channel button (CH) . The icon of the selected channel will
37 27
flash in the LC-display.
2. Then press the RESET button of the sensor.
43
As soon as the weather station has established a connection with the outdoor sensor
it automatically begins to receive the DCF radio signal. This process takes several
minutes and is indicated in the LC display by a flashing radio tower symbol .
5
When the DCF radio signal is being successfully received, the radio tower symbol
is shown permanently in the display. If at the time of putting the device into opera-
tion it is not possible to synchronise with the atomic clock, you can also carry out
the clock adjustments manually ("Setting the 12 / 24 hour mode / °C / °F / hPa /
inHg / time zone / time / date / language manually").
GB 15