Scene Mode Scheduler; Pre-Positions And Tours - Bosch MIC IP starlight 7000i User Manual

38 en | Camera
4.
5.
Note: Tour B is now intended for use with the 'IVA while moving' functions.
Compass
The camera allows a user to display the compass heading of the camera in the lower-right
corner of the image display. The camera displays the cardinal or intercardinal (N, NE, E, SE, S,
SW, W, NW) heading in which the camera is pointing.
Notice!
The compass feature is not compatible with Bosch's Intelligent Tracking feature. If Intelligent
Tracking is activated, the camera automatically disables the display of the compass heading.
Once Intelligent Tracking is deactivated, the camera returns the compass heading to the
display.
You must first calibrate the camera to North before the camera displays accurate compass
headings. The camera uses this calibration, usually set to magnetic North, as the zero degree
pan position and as the North compass heading. The camera then displays the compass
heading based on the number of degrees from the North calibration point.
To set the North calibration point:
1.
2.
3.
North point
–
–
6.8

Scene Mode Scheduler

The scene mode scheduler is used to determine which scene mode should be used during the
day and which scene mode should be used during the night.
1.
2.
3.
6.9

Pre-positions and Tours

The camera can store up to 256 preset scenes. You can define the individual scenes that
comprise a Pre-position Tour.
You define individual pre-position scenes, then use these scenes to define the Pre-position
Tour. The tour starts from the lowest scene number in the tour and progresses sequentially to
the highest scene number in the tour. The tour displays each scene for a specified dwell time
before advancing to the next scene.
By default, all scenes are part of the Pre-position Tour unless removed.
White light (marked with #)
Select this checkbox to include white light in the scene.
To define a Pre-position Tour:
1.
2017.11 | 1.2 |
Use the View Control dialog box to make the necessary camera movements.
Click the Stop Recording button to save all actions.
Determine the North compass heading, then move the camera to that position.
Select the radio button On for the parameter Compass.
Click the button next to North point to set the calibration point.
Click the Set button to overwrite the existing North point. A dialog box appears with the
message, "Overwrite North point?" To confirm, click OK. To cancel, click Cancel.
Click the Clear button to reset the North point to factory defaults. A dialog box appears
with the message, "Reset North point to factory defaults?" To confirm, click OK. To
cancel, click Cancel.
Select the mode you wish to use during the day from Marked range drop-down box.
Select the mode you wish to use during the night from Unmarked range drop-down box.
Use the two slider buttons to set the Time ranges.
Create the individual pre-positions.
By default, all scenes in the list Pre-positions are in the Pre-position Tour.
User Manual
MIC IP starlight 7000i
Bosch Security Systems