Advanced - Bosch MIC IP starlight 7000i User Manual

MIC IP starlight 7000i
Force registration now
You can force the registration by transferring the IP address to the DynDNS server. Entries
that change frequently are not provided in the Domain Name System. It is a good idea to force
the registration when you are setting up the device for the first time. Only use this function
when necessary and no more than once a day, to avoid the possibility of being blocked by the
service provider. To transfer the IP address of the camera, click the Register button.
Status
The status of the DynDNS function is displayed here for information purposes. You cannot
change any of these settings.
9.3

Advanced

The settings on this page are used to implement advanced settings for the network.
Operation
The operation mode determines how the camera communicates with Cloud-based Security
and Services.
–
–
–
Cloud state
This field identifies any cloud-based services with which the camera communicates.
–
–
Authentication
If a RADIUS server is employed in the network for managing access rights, authentication must
be activated here to allow communication with the unit. The RADIUS server must also contain
the corresponding data.
To configure the unit, you must connect the camera directly to a computer using a network
cable. This is because communication via the network is not enabled until the Identity and
Password parameters have been set and successfully authenticated.
Identity
Enter the name that the RADIUS server is to use for identifying the camera.
Password
Enter the password that is stored in the RADIUS server.
TCP port
The device can receive data from an external TCP sender, for example an ATM or POS device,
and store it as metadata. Select the port for TCP communication. Select Off to deactivate the
TCP metadata function.
Sender IP address
Enter the IP address of the TCP metadata sender here.
Bosch Security Systems
Select Auto to allow the camera to poll the server a few times; if no contact is made, it
stops polling.
Select On to constantly poll the server.
Select Off to block polling.
If you have registered the device on a cloud-based service such as Bosch Remote Portal,
then this field identifies this fact ("Registered on Bosch Remote Portal").
Note: The button (Connect to Bosch Remote Portal) to connect to the device with that
service is active.
If you have not registered the device, then the message, "Not running. (Automatic IP
assignment not active)" appears.
Note: The button (Connect to Bosch Remote Portal) to connect to the device with that
service is not active.
User Manual
Network | en 51
2017.11 | 1.2 |