Bosch MIC IP starlight 7000i User Manual page 37

MIC IP starlight 7000i
Note: If you would like to pan/tilt manually, or to use recording Tour A / Tour B, while using
the "IVA while moving" feature, then you must set the value in this field to <5.
Maximum tilt speed [%]
Select the maximum tilt speed (in percent). Settings range from 1 to 100. The default is 100.
Note: If you would like to pan/tilt manually, or to use recording Tour A / Tour B, while using
the "IVA while moving" feature, then you must set the value in this field to <5.
Tracking zoom-out limit [%]
This parameter defines the zoom ratio percentage to which the camera zooms out after
Tracking idel time [s] stops tracking, or if Intelligent Tracking loses visibility of an object being
tracked. This allows the camera to re-acquire the target in a new, wider FoV. Settings range
from 0 to 100. The default is 50.
Tracking idle time [s]
This parameter allows the camera to stop tracking motion of certain objects, such as a tree or
a flag swaying in the wind, in a confined area after the specified number of seconds. Settings
range from 5 to 120. The default is 30.
Auto pan left limit
Sets the left Auto Pan limit of the camera. Use the preview window to move the camera to the
left pan limit and click the button. The camera will not move past this limit when in Auto Pan
Between Limits mode (AUX 2 ON).
Auto pan right limit
Sets the right Auto Pan limit of the camera. Use the preview window to move the camera to
the right pan limit and click the button. The camera will not move past this limit when in Auto
Pan Between Limits mode (AUX 2 ON).
Notice!
Possible unintended camera operation
When setting hard pan limits, ensure that you set the left limit and the right limit at least 10°
apart. Pan limits of less than 10° apart could prevent the camera from operating properly.
Tilt up limit
Sets the upper tilt limit of the camera. Use the preview window to move the camera to the tilt
limit and click the button.
Pan limit left
Set the appropriate pan limit on the left.
Pan limit right
Set the appropriate pan limit on the right.
Tour A / Tour B
Starts and stops the recording of a recorded (guard) tour.
The camera can make up to two (2) recorded tours. A recorded tour saves all manual camera
movements made during the recording, including its rate of pan, tilt and zoom speeds, and
other lens setting changes. The tour does not capture camera video during the recording of
the tour.
Note 1: You can save a total of 15 minutes of recorded actions between the two tours.
To record a tour:
1.
2.
3.
Bosch Security Systems
Click the Start Recording button. The system prompts you to overwrite the existing tour.
Click Yes to overwrite the existing tour movements.
Click the View Control link, under the image cameo, to access the directional and zoom
controls.
User Manual
Camera | en 37
2017.11 | 1.2 |