Control Valve - Remove (H.40.B.13 - F.10.A.10); 435, 445, 445Ct - Case 445CT Repair Manual

Control valve - Remove (H.40.B.13 - F.10.A.10)

435, 445, 445CT

1. Place a shop towel under the loader control valve.
2. Remove the cap from the hydraulic reservoir.
3. Reservoir - Apply vacuum (A.10.A.22 - F.35.A.50)
Connect a vacuum pump to the hydraulic reservoir.
4. Start the vacuum pump.
5. Tag all of the hydraulic lines and hoses and port
locations on the loader control valve.
6. Loosen and disconnect all of the hydraulic lines and
hoses from the loader control valve.
7. Install plugs and caps on all of the fittings and port
locations.
8. Stop the vacuum pump.
9. Tag and disconnect all of the electrical connections
from the loader control valve.
10. Remove the clip(s) and the pin(s) from the control
linkage and remove the control linkage from the
loader control valve.
WORKING ARM - SINGLE ARM Lift
1 04/05/2005
H.40.B / 27
1
BD04C144
2
BD04C145