Zn (Atz[0|1]) - W&T 58620 Manual

W&T

5.4.11 Zn (ATZ[0|1])

Reset the LAN-Modem
The Zn command quits any active connection and resets the
firmware of the LAN-Modem to the parameters stored in the
non-volatile memory. By specifying 0 or 1 you can select one
of the two available reset profiles (see also &Wn command).
Which profile is loaded after the LAN-Modem is turned on is
defined by the &Yn command.
•
Load stored reset profile 0.
• Z1
Load stored reset profile 1.
Additional information can be found in the following sections:
&V1: Read the configuration profiles
&Wn: Store the current settings in the specified profile
&Yn Specifying the configuration profile after a reset.
Subject to error and alteration
Modem Operation
53