Table of Contents
Advertisement
W&T
Assigning the IP address
Clicking on the Next button assigns the network parameters to
the LAN-Modem. After acknowledging the resulting message,
all the columns in the WuTility device list are filled in with
information.
This concludes the network-side startup of the LAN-Modem.
With the exception of a few special settings, the rest of the
configuration is done as for a standard dial-up modem using
the serial port and AT commands.
1
Changing network parameters is protected by the
system password. To prevent improper access, we
recommend assigning a system password for any LAN-Modems
in use. Additional information can be found in the section
Extended configuration of the LAN-Modem.
14
Advertisement
Table of Contents
