Table of Contents
Advertisement
W&T
2.1
Configuring network parameters with WuTility
The Windows tool WuTility version 3.0 and higher allows not
only inventorying of LAN-Modem, Com-Server and Web-IO
installations, but also convenient assignment of the following
network-side basic parameters:
•
IP address
•
Subnet mask, gateway address
•
Activating/deactivating BOOTP/DHCP
Assigning requires that the PC and LAN-Modem be in the same
subnet. In firmware revisions 1.45/1.14 and higher the function
is independent of the current address settings in the LAN-Mo-
dem, i.e. even changes to parameters not matching the network
are easily made. Any system password which has been set must
however in this case be known.
Downloading and installing WuTility
The most current version can always be found at our Web site
under the following address:
http://www.wut.de
From there use the menu tree on the left side to navigate:
Downloads r Serial Com-Servers
After unzipping the ZIP file, begin installation by double-
clicking on the file wutility_xxxus.msi. WuTility is started from
Start r Programs r W&T Software Toolkit r WuTility
Starting the assignment dialog
First be sure that both the LAN-Modem and the computer you
are using are connected to the same network and are in the
12
Assigning the IP address
Advertisement
Table of Contents
