Assigning The Ip Address - W&T 58620 Manual

W&T
2

Assigning the IP address

The LAN-Modem is factory set to IP address 0.0.0.0. Before you can make
the entry in the LAN-Modem, you need to specify an IP address that is valid
for your network. You system administrator will provide you with this. If
you have only a small network with no routing, use the IP address of your
PC and simply change the last digit. The IP address must be unique within
the network!
.
Assigning IP address, subnet mask and gateway address
using WuTility management tool
.
Assigning IP address, subnet mask and gateway address
through the serial port
.
Assigning IP address, subnet mask and gateway using
DHCP/BOOTP protocol
.
Using the ARP command
Subject to error and alteration 11