All At Commands - W&T 58620 Manual

W&T

5.4 All AT commands

The LAN-Modem accepts all the commands in the table whose
processing is done according to the following rules:
Command Description
Dx Dial IP address and go online
A Pick up incoming call
O Return to an existing connection
H Close connection
Zn Close connection and reset modem
En local echo on|off
Qn Suppress result codes on|off
Vn Result codes as text instead of number
In Firmware information
Sn? Read S register
Sn=x Modify S register
&Cn DCD option
&Sn DSR option selection
&Dn Modem response to DTR option
&Kn Flow control between modem and terminal
&Fn Restore
&Vn Display configuration profiles/connection data
&Wn Active profile write
&Yn Active profile read
&Zn=x Destination IP address write
%Bn Baudrate between modem and terminal
%Dn Number of data bits beween modem and terminal
%Pn Parity bit between modem und terminal
%Sn Number of stop bits between modem and terminal
%Nn Allow remote maintenance over network
**n Start firmware update
• No other command may follow A, D, O, Z and &Z in the same
command line. In the case of A, O and Z they are ignored,
and in the case of D and &Z they are considered as part of
the dialed number.
Subject to error and alteration
Modem Operation
Parameter
IP-Adresse
---
---
---
n=0, 1
n=0, 1
n=0, 1
n=0, 1
n=0 - 8
n=0 - 40
n=0 - 255
n=0, 1
n=0, 1
n=0, 1, 2, 3
n=0, 3, 4, 5, 6
n=0, 1
n=0, 1, 2
n=0, 1
n=0, 1
n=0, 1, 2, 3
n=2 - 8 (5)
n=7, 8
n=0, 1, 2
n=1, 2
n=0, 1
n=0, 1
39