Table of Contents
Advertisement
Display 1
Display 2
LVDS
DP
Use of DP Adapter Converters (3rd party accessories) can provide HDMI panel support.
The DP to HDMI supports the HDMI 1.4a specification including audio codec.
Supporting 4K display requires two DDR channels of the same size. Performance
degradations exists while running 4K content for systems using single channel system
memory (compared to using dual channel).
High-Bandwidth Digital Content Protection (HDCP)
HDCP is the technology used to protecting high-definition content against unauthorized copying or interception
between the source (computer, digital set top boxes, and so on) and the sink (panels, monitor, and TVs). The ECX-
KBL-U supports HDCP 2.2 for content protection over-wired displays (HDMI, DVI, and DP). The HDCP 1.4 keys are
integrated into the processor and customers are not required to physically configure or handle the keys.
3.8. Power Consumption
In order to ensure safe operation of the board, the input power supply must monitor the supply voltage and shut
down if the supply is out of range – refer to the actual power supply specification. Please note, in order to keep the
power consumption to a minimal level, boards do not implement a guaranteed minimum load. In some cases, this can
lead to compatibility problems with ATX power supplies that require a minimum load to stay in regulation. The ECX-
KBL-U board must be powered through the ATX+12V-4p (4-pole) connector using standard ATX power supply.
ATX12V supply: ATX+12V-4p connector must be used in according to the ATX12V PSU standard.
Hot Plugging power supply is not supported. Hot plugging might damage the board.
The requirements to the supply voltages are as follows:
Table 7: Supply Voltages
Supply
Min.
+12 V
11.4 V
www.kontron.com
Display 3
HDMI
Max.
Note
12.6 V
Should be ±5% for compliance with the ATX specification
Max. Resolution (Px) at 60 Hz
Display 1
Display 2
1920x1200
4096x2304
ECX-KBL-U - User Guide, Rev. 1.0
Display 3
3840x2160
// 22
Advertisement
Table of Contents
