Filling Aid; Filling The Filling Chamber Using The Filling Aid - Storz & Bickel GMBH Crafty Instructions For Use Manual

8 . F I L L I N G T H E F I L L I N G C H A M B E R
Take care that the Screens are
not obstructed with plant ma-
terial. To guarantee optimal
results, we recommend cleaning the
Screens after each vaporization cycle
with the enclosed Cleaning Brush.
The upper Screen especially can be-
come clogged with plant material and
so make inhaling difficult. In this case,
remove the Screen as in Chapter 10.
"Disassembling, Cleaning and Assem-
bling", page 23 and clean or insert a
new Screen.
Then re-mount the Cooling Unit by ro-
tating it clockwise through 90°.
As soon as the lower Filling Chamber
Screen is clogged or shows depos-
its, a cleaning of the Filling Chamber
is needed. For that, please firstly re-
move the lower Screen as described
in Chapter 10.3. "Removal of the lower
Filling Chamber Screen", page 26
and clean the Filling Chamber with
a cotton stick that has been soaked
in alcohol. Please make sure that no
alcohol drops into the inner of the de-
vice. After cleaning, a new screen is to
be inserted.

8.1. Filling Aid

The Filling Aid supplied with the unit
makes filling the Filling Chamber an
easy and clean operation and serves
as a magazine for transporting and
storing plant material already ground
in the Herb Mill.
To fill the Filling Aid, remove the up-
per cap and fill the bowl incl. plug with
ground plant material. Replace the up-
per cap and close it.
Filled Filling Aid (upper cap removed)
20
8 . F I L L I N G T H E F I L L I N G C H A M B E R
8.2. Filling the Filling Chamber using
the Filling Aid
Upper
Remove the Cooling Unit from the Va-
Cap
porizer and remove any residues that
may be in the Filling Chamber. The
Filling Chamber Tool can be a help in
Plug
doing this.
Remove the lower cap of the Filling Aid
by turning counterclockwise. Place the
Bowl
Filling Aid on the Vaporizer and attach
by turning it clockwise. Remove the
upper cap from the Filling Aid. Pull the
plug and use it to fill a portion of plant
material through the central opening
Lower
into the Filling Chamber.
Cap
Make sure that the Filling
Chamber is not overfilled (see
Chapter 8. "Filling the Filling
Chamber", page 19).
Fill the Filling Aid to the lower rim (see
the two following drawings)!
Overfilling leads to clogging of the
Screens and can make inhaling more
difficult.
Filling the Filling Chamber with the Filling Aid
The lower rim of the Filling Aid must be
above the top level of the plant material
Then re-insert the plug into the central
opening and screw on the upper cap of
the Filling Aid. Unscrew the Filling Aid
with a 90° rotation and screw on the
lower cap again. Then re-mount the
Cooling Unit by rotating it clockwise
through 90°.
21