Heating Up; Temperature Setting; Reset To Default Settings; Filling The Filling Chamber - Storz & Bickel GMBH Crafty Instructions For Use Manual

7. C O M M I S S I O N I N G A N D O P E R AT I O N

7.2. Heating Up

The CRAFT Y Vaporizer provides two
temperature levels that are set in the
factory: The basic temperature at
180°C (356°F) and the booster tem-
perature at 195°C (383°F).
Both the basic and booster
temperatures can be altered
using a smartphone and the
CRAFT Y App (see Chapter 11.4. "Set-
ting Temperature with the CRAFT Y
App", page 29).
Switch on the device (heating up the
Vaporizer with full Filling Chamber and
Cooling Unit mounted is recommend-
ed). To do this, press the orange ON/
OFF switch for at least half a second.
The Vaporizer responds with a short
vibration. The vibration does not take
place if there is a fault.
The LED display indicates the heating
operation up to the basic temperature
by a steady red light. Heating up the
heat exchanger can take up to two min-
utes, depending on the temperature
setting and battery charge level. Once
the basic temperature is reached, this
is signaled by a short double vibration
and a steady green light.
If the basic temperature can no longer
provide adequate evaporation, the
booster temperature can be activated
by means of a double-click on the
orange-colored ON/OFF switch. The
LED displays the heating-up operation
for the booster temperature by a red
flashing signal. Once the booster tem-
perature is reached, this is signaled by
a short double vibration and a green
flashing signal.

7.3. Temperature Setting

The levels for the basic and booster
temperatures can be altered with the
aid of a smartphone and the CRAFT Y
App. See Chapter 11. "CRAFT Y App",
page 27.

7.4. Reset to Default Settings

It is possible to reset settings (see
Chaper 11.1. "Default Settings", page
27) which were changed using the
CRAFT Y App. The reset is made by
pressing the ON/OFF button for ten
seconds while the CRAFT Y Vaporizer
is switched on.
If the ON/OFF button has been
pressed for ten seconds, the signaling
of the reset is made by the following
running lights sequence: red/green/
blue/red/green/blue/red/green/blue.
The CRAFT Y Vaporizer also vibrates
while the lights sequence is running.
18
8 . F I L L I N G T H E F I L L I N G C H A M B E R
Turn the Cooling Unit with a 90° rota-
tion counterclockwise in order to re-
move it from the Vaporizer.
Removal of Cooling Unit (with Mouthpiece)
Always fill the Filling Chamber com-
pletely up to the plastic rim with ground
plant material. Do not compress the
plant material too much so that the
airflow is not unnecessarily impeded.
Remove any excess plant material left
around the filling aperture so that it is
clean and allows the Cooling Unit to be
fitted.
If the Filling Chamber is only
partially filled, then the vapori-
zation material may shift
around; the hot air then bypasses the
vaporization material, so that no va-
porization can occur.
Filling Chamber properly filled
If the Filling Chamber is not to be filled
completely, it is recommended to
place the included Liquid Pad over the
herbs, and then mount the Cooling Unit
on the Vaporizer.
Filling Chamber partially filled, with Liquid
Pad placed on top
19