Filling The Filling Chamber Using The Filling Aid; Application - Storz & Bickel GMBH Crafty Instructions For Use Manual

8. FILLING THE FILLING CHAMBER
8.2. Filling the Filling Chamber us-
ing the Filling Aid
Remove the Cooling Unit from the Va-
porizer and remove any residues that
may be in the Filling Chamber. The
Filling Chamber Tool can be a help in
doing this.
Remove the lower cap of the Fill-
ing Aid by turning counterclockwise.
Place the Filling Aid on the Vaporizer
and attach by turning it clockwise. Re-
move the upper cap from the Filling
Aid. Pull the plug and use it to fill a por-
tion of plant material through the cen-
tral opening into the Filling Chamber.
Make sure that the Filling
Chamber is not overfilled (see
Chapter 8. "Filling the Filling
Chamber", page 18).
Fill the Filling Aid to the lower rim (see
the two following drawings)!
Overfilling leads to clogging of the
Screens and can make inhaling more
difficult.
Filling the Filling Chamber with the Filling
Aid
The lower rim of the Filling Aid must be
above the top level of the plant material
Then re-insert the plug into the central
opening and screw on the upper cap
of the Filling Aid. Unscrew the Filling
Aid with a 90° rotation and screw on
the lower cap again. Then re-mount
the Cooling Unit by rotating it clock-
wise through 90°.
20

9. APPLICATION

Mount the Cooling Unit on the Vapor-
izer and heat up. This ensures that
both the Filling Chamber and the ma-
terial to be vaporized are preheated
and the vaporizing can begin as soon
as the heating process is completed.
Caution! Hot surface!
After using the CRAFTY Va-
porizer, do not touch the Fill-
ing Chamber until it has cooled down
again.
Once the Vaporizer has reached the
set temperature (steady green light
for the basic temperature and flash-
ing green for the booster temperature,
each also accompanied by a short
double vibration) and the Mouthpiece
is folded out, then the inhaling pro-
cess may begin.
Using the CRAFTY Vaporizer
Take the Mouthpiece between the
lips, and inhale slowly and evenly for
several seconds.
Please note the following about va-
por generation: the more intense the
vapors, the greater the impairment of
the flavor.
A very high intensity (or den-
sity) of the vapor can lead to
irritation of the respiratory
passages from the concentration of
the aromas and fragrances.
In this case, the temperature should
be lowered, so that the intensity of
the vapors is reduced (see Chapter
11.4. "Setting Temperature with the
CRAFTY App", page 28).
The device is not to be used, if
the user has respiratory tract
or lung conditions. Depending
on the density, the vapor could irritate
respiratory tracts or lungs, which can
lead to coughing.
Inhale only half the amount of
air you can normally manage.
Hold your breath for a few
seconds and exhale slowly. It is advis-
able to deliberately concentrate on
your breathing process.
After vaporization, turn off
CRAFTY Vaporizer. To do this, press
the orange ON/OFF switch for at least
half a second. The Vaporizer acknowl-
edges the switching off with a short
vibration.
Allow the Vaporizer to cool down be-
fore it is packed away.
21
the