Application - Storz & Bickel GMBH Crafty Instructions For Use Manual

9. A P P L I C AT I O N
Mount the Cooling Unit on the Vaporiz-
er and heat up. This ensures that both
the Filling Chamber and the material
to be vaporized are preheated and the
vaporizing can begin as soon as the
heating process is completed.
Caution! Hot surface!
After using the CRAFT Y Va-
porizer, do not touch the Fill-
ing Chamber until it has cooled down
again.
Once the Vaporizer has reached the set
temperature (steady green light for the
basic temperature and flashing green
for the booster temperature, each also
accompanied by a short double vibra-
tion) and the Mouthpiece is folded out,
then the inhaling process may begin.
Using the CRAFTY Vaporizer
Take the Mouthpiece between the lips,
and inhale slowly and evenly for sev-
eral seconds.
Please note the following about va-
por generation: the more intense the
vapors, the greater the impairment of
the flavor.
A very high intensity (or densi-
ty) of the vapor can lead to irri-
tation of the respiratory pas-
sages from the concentration of the
aromas and fragrances.
In this case, the temperature should
be lowered, so that the intensity of
the vapors is reduced (see Chapter
11.4. "Setting Temperature with the
CRAFT Y App", page 29).
The device is not to be used, if
the user has respiratory tract
or lung conditions. Depending
on the density, the vapor could irritate
respiratory tracts or lungs, which can
lead to coughing.
Inhale only half the amount of
air you can normally manage.
Hold your breath for a few sec-
onds and exhale slowly. It is advisable
to deliberately concentrate on your
breathing process.
After vaporization, turn off
CRAFT Y Vaporizer. To do this, press
the orange ON/OFF switch for at least
half a second. The Vaporizer acknowl-
edges the switching off with a short
vibration.
Allow the Vaporizer to cool down be-
fore it is packed away.
22
10. D I S A S S E M B L I N G , C L E A N I N G A N D A S S E M B L I N G
When the vapors are cooled, it is in-
evitable that a small fraction is con-
densed on the internal surfaces of the
Cooling Unit.
The component parts of the Cooling
Unit, including the Mouthpiece must
be thoroughly cleaned on a regular ba-
sis to guarantee proper operation and
pure flavor.
Product Overview of the CRAFTY Cooling Unit
The Cooling Unit consists of:
Cap Lock
Mouthpiece
Mouthpiece Seal Ring
Cooling Unit Cap
Base Seal Ring
(small)
Cooling Unit Base
the
Upper Screen
(coarse mesh width)
Base Seal Ring
(large)
For hygienic reasons, it is also neces-
sary to clean these components when
the Vaporizer is to be used by a differ-
ent person.
The condensate can be sticky.
The Cooling Unit can be dis-
mantled more easily when it
first warmed up.
23