Storz & Bickel GMBH Crafty Instructions For Use Manual page 13

10. D I S A S S E M B L I N G , C L E A N I N G A N D A S S E M B L I N G
10.1. Disassembling and Reassem-
bling the CRAFTY Cooling Unit
Turn the Cooling Unit with a 90° rota-
tion counterclockwise in order to re-
move it from the Vaporizer.
Pull out the Mouthpiece from the Cool-
ing Unit Cap, rotate slightly back and
forth while doing this, and pull off the
Mouthpiece Seal Ring.
Pulling the Mouthpiece from the Cooling Unit
Cap
Open the Cap Lock by pulling it rear-
wards.
Opening the Cap Lock
Remove the Cap Lock from the Cap by
pulling up at one side.
If the Cooling Unit must be im-
mersed into alcohol (ethanol)
the Cap Lock only has to be
removed from the Cooling Unit. Ex-
tended contact with alcohol can lead
to whitening of the Cap Lock Label or
disintegration of the glue.
Removal of the Cap Lock
Separate the Cooling Unit Cap from
the Cooling Unit Base by pulling off the
cap upwards.
24
10. D I S A S S E M B L I N G , C L E A N I N G A N D A S S E M B L I N G
Pull the Cooling Unit
Cap from the Cooling Unit Base
Remove the large and small base Seal
Rings. Lever out the large Seal Ring
from the recess in the notch using the
Filling Chamber Tool.
Removal of the large base Seal Ring
Push the upper Screen downwards out
of the Filling Chamber Cap from above
by using the Filling Chamber Tool sup-
plied.
Pressing out the upper Screen
Reassemble in reverse order.
When assembling, make sure
that Seal Rings are properly
seated. The Mouthpiece Seal
Ring, especially, must sit completely in
the Cap and be no longer visible.
The upper Screen must be inserted
carefully into the groove provided. Dis-
regarding this may allow plant parti-
cles to enter the Cooling Unit, so block-
ing this or be inhaled.
25